Bolong Waterproof Material Co

Series of water-based color multi-functional waterproof coatings
One product introduction
Acrylic waterproof coating series water-based color multi-functional waterproof coating is a one-component water-based acrylic waterproof coating. This coating uses pure acrylic emulsion and It is made of multi-polyacrylic acid emulsion as the base material, mixed with a variety of additives and inorganic fillers. After coating, a tough and elastic waterproof membrane with strong adhesion can be formed, which together with the base layer forms a complete waterproofing system combining rigidity and softness to adapt to various deformations of the structure and achieve long-term waterproofing and impermeability. This product can be made into various colors as needed.
Second Product Features
Can be applied directly on wet or dry substrates of various materials.
The coating is tough and strong, water-resistant, resistant to high and low temperatures, and has good aging resistance. Especially in terms of UV resistance, it is better than general waterproof products.
Strong adhesion, good extensibility, optional colors.
Single component, simple construction and short construction period.
Non-toxic and odorless, it is a substitute for solvent-based waterproof coatings such as polyurethane coatings that are currently commonly used.
With various colors, it can be used as decorative waterproof coating.
Three Scope of Application
This product is widely used in cast-in-place concrete roofs, walls, asbestos cement tiles, roofs, indoor bathrooms, warehouses and other parts to renovate and repair leaks in old building surfaces for waterproofing and moisture-proofing. It can also be used as a protective layer for other waterproof layers.
Four Main Technical Indicators Implementation Standards/"Polymer Emulsion Architectural Waterproof Coating"
Technical Indicators Type I Technical Indicators Type II
Solid Content
Explicit Drying Time
Real Drying Time
Tensile strength
Elongation at break
Low temperature flexible rod winding ℃ No cracks ℃ No cracks
Impermeability Impermeability Impermeability Impermeability
Five construction methods
Base layer treatment The base layer is firm, firm and flat, with no sharp corners, no rust, oil stains and obvious water stains. The inner and outer angles should be made into arc shapes with cement mortar or sealing paste. The diameter of the inner angle should be larger than that of the outer angle, and the diameter of the outer angle should be larger than that of the outer angle. Cracks in the base layer and grooves left by pipe roots should be filled with sealing materials.
Base treatment agent In order to improve the adhesion, the base treatment agent should generally be applied. The base treatment agent can be prepared on site by diluting the waterproof coating with water. It is recommended to add the appropriate amount of water. For special base layers, special supporting base treatment agents can be used. The amount of base treatment agent is about m2.
Thick waterproof coatings should be applied in separate passes to form a film. The last coat can be applied only after each coat is dry. Generally, the painting directions are perpendicular to each other at intervals of several hours. When it is necessary to add carcass reinforcement material, the carcass material should be flat, wrinkle-free and soaked. The thickness of the coating film under the carcass should not be less than that of the upper coating film. The dosage and thickness of the carcass should be no less than ㎡㎡ , the amount of paint required for a thick coating film is approximately ㎡.
Six-pack transportation and storage
The product is placed in a clean, dry and airtight plastic barrel, with a packaging capacity of /barrel/barrel.
Transportation is subject to non-dangerous goods requirements. During transportation, prevent rain, exposure, squeezing, collision, and inversion, and keep the packaging intact.
The product should be stored in a ventilated, dry and cool place, away from direct sunlight. The storage temperature should not be lower than ℃. Validity year